Reply with Quote...check SETP settings?
Fadal 6535 Z travel height
I purchased a 2001 Fadal 6535, it’s supposed to have 65x35x 34” travel.
On the Z axis it will only descend 28” instead of 30”. I’ve changed the software module to a newer one (version 103.5) with no change on the distance of travel.
I will attach pictures of the z axis motion board along with the cpu that shows software versions and EPROMs. Any help is greatly appreciated, I don’t want to run extended length tool holders to be able to reach parts or create sub plates to bring the table height up. I’d like to be able to use the t slots and keep the rigidity in tooling.
Similar Threads:
Re: Fadal 6535 Z travel height
...check SETP settings?
The SETP on size is set to 65 35 34Originally Posted by machinehop5
Re: Fadal 6535 Z travel height
...this is an odd problem with Z travel you have. The EPROMS ELE-1444 and the jumpers in your photo all look correct for 1010-6A Z axis....Have you tried Zero Memory? But, before trying make sure to save ALL Programs, Tool Comps, and if, you have the DATC type Tool changer do a "Sort Tools" Function or you'll have problems after Zero Memory.
https://www.fadalcnc.com/media/pdf/Z..._Procedure.pdf
Last edited by machinehop5; 07-04-2021 at 08:49 PM. Reason: tools
I have also done this procedure when I changed to the updated software module and again when I changed it back to the original. It was very sluggish and slow with the new software version. I’m wondering what are the possibilities that the previous owners could of had the eprom written to stop it at -28.00”? I don’t know how those are written but I know they can be copied and reproduced.
Re: Fadal 6535 Z travel height
...easy to find out if the Z proms have been reprogrammed...swap them with X or Y proms or purchase a new set for 35 if, all of them may have been changed.
https://www.fadalcnc.com/index.php/ele-1444.html
Re: Fadal 6535 Z travel height
...one more thing to check is use the "SV" Command to view Zero Offset value stored on the Z card
I’ll check that in the morning. Thank you.
Re: Fadal 6535 Z travel height
...your welcome. But, of coarse the Zero Offset for Z would affect the Tool change position. So, I dont think its the problem.
Sleep well,...
DJ
EPROMS I bought a new set and the problem was solved...your welcome. But, of coarse the Zero Offset for Z would affect the Tool change position. So, I dont think its the problem.
Sleep well,...
DJ
