Anyone had this kind of problem?
I have been struggling with this problem whole week. At this forum i coulndt find the anwser.
I want to use UT, 1 Tool measuring cycle thro all 1-20 tools. Problem is that i get same error "Move turret to tool number 1 and SETTO" Seems everything clear, i do what i have been asked, and the same message keeps coming back. In fadal book ERROR List i found few steps to solve this problem, but its still asking to move turret to tool 1. Even i can see already T1, and SETTO have been written down. How to solve this? i am out of ideas.
Similar Threads:
Anyone had this kind of problem?
...did you read the manual about the UT Command might help. Page 110
https://www.fadalcnc.com/media/pdf/t...atorManual.pdf