FADAL VMC15 XT X axis wire

[ballistic42]

I am needing to know what the diameter of the X axis motor wire cover diameter is. I don't have the machine in front of me so I can't look. I think it's 3/4 but could be 1/2'' not sure. I know it's liquatite product. The outside diameter of the sheathing would be helpful.

Thanks,

Jeff

Similar Threads:

• Need Help!- Fadal VMC15 Model 914
• FADAL VMC15 Powering up to AXIS CONTROLLER DOES NOT RESPOND and cant get past it
• Need Help!- Fadal VMC15 Table problems - y axis has mind of it's own!
• Need Help!- electric help on fadal vmc15
• Newbie- Fadal VMC15 intro?

[rwskinner]

I have to go look but I'm pretty sure it's 1/2" seal-tite flex conduit. Let me go look.

[ballistic42]

I appreciate that! I am replacing the strain reliefs on both ends when I replace the sheathing.

[rwskinner]

Actually, mine is nothing more than a heavy 5/8 or 3/4" rubber hose with a 1/2"NPT Barb fitting on the roof and a 3/8 to 1/2" bushing and barb fitting on the motor side.
It's been like that a long time and is holding up fine. It was like that when I got it. Honestly, probably easier and cheaper and more flexible than seal-tite.

[ballistic42]

Actually, mine is nothing more than a heavy 5/8 or 3/4" rubber hose with a 1/2"NPT Barb fitting on the roof and a 3/8 to 1/2" bushing and barb fitting on the motor side.
It's been like that a long time and is holding up fine. It was like that when I got it. Honestly, probably easier and cheaper and more flexible than seal-tite.

I really appreciate you taking the time to look!!
Thanks
Jeff