Parity error
New problem today
Can punch but not send a program. Get parity error sometimes other times nothing at all. Machine triggers pc to send program.
Rs232 test passed
Tried another pc and cable from my other fadal. No different
Swapped rs232 cards. No change
All settings correct
A little stumped now. Any ideas?
Similar Threads:
Re: Parity error
...something to check is how old is the CPU memory Battery. I just went thru this problem of Transmit/Receive to my 2005 VMC4020 and it turned out to be battery.
https://www.fadalcnc.com/ele-0082.html
Turn POWER OFF and check with a volt meter. This video shows how to replace without damaging the PCB
DJ
Last edited by machinehop5; 04-05-2020 at 11:15 AM. Reason: link
Checked battery 3.67v so it's good.Originally Posted by machinehop5
Perfoemed the following with no success
Swapped rs232 card with known good one
Swapped cpu board with known good one
Swapped rs232 cable from cab to board with known good one
Swapped pc
Swaped pc cable
Then installed the suspect gear on another fadal and it all worked fine so the hardware is good.
Maybe another card has issues
Re: Parity error
19200 baud, Even, 7, 1, software flow XON/XOFF is want I use. TA,1,0,0 first line of program
Re: Parity error
Check your machine grounding. I had a heck of a time with "parity errors" that all went away when I moved the machine to the other side of the shop.
All sorted. Made a new cable tried a third pc and all worked.
I think both cables have 'well used' db9 plugs so will swap them out with new ones
Thanks for the assistance
Reply with Quote
