4020 with extended Z

[adaprecision]

I just purchased a 4020 XT and I hope someone can answer my question, search didn’t turn anything up.

Will a 4020 XT fit through an 8’ garage door? I know the Z axis motor will need to be removed and maybe the cable carrier also, but will it fit with those removed?

Thanks in advance .

Similar Threads:

• Which Fadal? 4020 1992 with 4th Axis or 4020 1998?
• X3 extended table
• looking for extended memories on 18-m
• X3 Extended Table
• Extended base for the X2

[machinehop5]

https://www.fadalcnc.com/media/pdf/t...Procedures.pdf
I see something about 7' 5" on page 47

[ianagos]

It should but you may have to remove the ballscrew bearing mount. I fit a 5020a standard column under 83” so the extra 8” should be fine under 96”

[rodney247]

i Have a 4020A High column and it measures 93" with the z axis servo motor removed. But i think a 4020 high column (all box way machine) is a inch taller in the same condition

[rodney247]

If you remove the Z axis ballscrew you could prolly get it down to 90"....... worst case scenario remove the garage door get out the sawz-all and then patch and re-stucco the house