Problem VMC 4020 w. 88HS Control, glitches when left idle


Results 1 to 3 of 3

Thread: VMC 4020 w. 88HS Control, glitches when left idle

  1. #1
    Member
    Join Date
    Oct 2017
    Location
    Canada
    Posts
    23
    Downloads
    0
    Uploads
    0

    Default VMC 4020 w. 88HS Control, glitches when left idle

    We have a VMC4020 which has always had its issues related to the turret tool changer but it has developed a new and annoying habit in the last week.

    When making parts the machine behaves normally, however when left idle it will freeze up and go completely blank on the screen after about 30 minutes.
    We then have no ability to manually move axes or to home them and have to power down and restart. Then the machine behaves normally again (after we set CS). I had suspected the power supply but wouldnt it then also freeze up while operating?

    Anyone have any similar problems? What did you do to address them?

    Similar Threads:


  2. #2

    Default Re: VMC 4020 w. 88HS Control, glitches when left idle

    Is the LED on the 1030 card (Slot 8) still blinking when this happens?



  3. #3

    Default Re: VMC 4020 w. 88HS Control, glitches when left idle

    I would try Pulling every card and re-seat them on the motherboard



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

VMC 4020 w. 88HS Control, glitches when left idle

VMC 4020 w. 88HS Control, glitches when left idle