Can't change travel, Tool Changer values in Parameter Settings


Results 1 to 3 of 3

Thread: Can't change travel, Tool Changer values in Parameter Settings

  1. #1
    Member
    Join Date
    Dec 2009
    Location
    USA
    Posts
    482
    Downloads
    0
    Uploads
    0

    Default Can't change travel, Tool Changer values in Parameter Settings

    I aquired a 2003 TRM. It had been sitting for quite awhile.
    It lost its parameter settings.
    In haste, I reloaded some defaults so I could jog the Z down to clear a door.

    Now, I wanted to correctly reload the parameter settings.
    First, is there a way to default the control, clear everything to start again?

    The issue is that while I can change axis configuration, (its ok at X, Y, Z) it will not let me in to the field to change the travels, which it defaulted to and are incorrect.
    I can't remove references to ATC and # of tools either, cant change the spindle RPM, RPM Factor etc. Won't let me cursor to those settings.

    Attached are a couple of screen shots.
    I'm out of ideas.

    Thanks in advance.
    Marty

    Similar Threads:
    Attached Thumbnails Attached Thumbnails Can't change travel, Tool Changer values in Parameter Settings-parameter-screen-jpg   Can't change travel, Tool Changer values in Parameter Settings-sys-103-1a-jpg  


  2. #2
    Member
    Join Date
    Oct 2008
    Location
    United States
    Posts
    1446
    Downloads
    0
    Uploads
    0

    Default Re: Can't change travel, Tool Changer values in Parameter Settings

    Make sure they key is installed and turned on, or open the pendant and install a jumper across the switch. I'm not certain that's your problem but mine limits what I can change in setp unless the key is ON.



  3. #3
    Member
    Join Date
    Dec 2009
    Location
    USA
    Posts
    482
    Downloads
    0
    Uploads
    0

    Default Re: Can't change travel, Tool Changer values in Parameter Settings

    Quote Originally Posted by rwskinner View Post
    Make sure they key is installed and turned on, or open the pendant and install a jumper across the switch. I'm not certain that's your problem but mine limits what I can change in setp unless the key is ON.
    Thanks for the reply. My pendant does not have a key switch. That's not to say there isn't a place in the control cabinet to put the jumper in or slide a switch. That would make sense.

    Attached Thumbnails Attached Thumbnails Can't change travel, Tool Changer values in Parameter Settings-pendant-jpg  


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Can't change travel, Tool Changer values in Parameter Settings

Can't change travel, Tool Changer values in Parameter Settings

Can't change travel, Tool Changer values in Parameter Settings