Perhaps yor parameters are wrong. Can you type "SETP" at the command line to double check them?
Hello,
I have a Fadal 4020 CNC 88
Model 906-1
Serial 9205252
It is a 4020 but the axes only move 20 10 and Z Also moves half the distance.
I want to access the Machine configuration and the diagnostics mode but the control asks for an access code.
Does anyone knows?
Thanks
jolulank
Enviado desde mi Redmi 5 Plus mediante Tapatalk
Similar Threads:
www.doctornumerico.com
cnc physicians
Perhaps yor parameters are wrong. Can you type "SETP" at the command line to double check them?
Is there no key in the pendant? Sometimes the Keys are wired tied inside the Main cabinet. you need the key
Or if you can not find the keys ... its easy to bypass just open the Pendant i can't remember if the circuit is closed for lock or open... so either connect the wires or separate them that run to the lock. Done. its a very simple on/off type circuit.