Originally Posted by
ginner
Thanks for advice, man. Replaced and rewired my rs232 cable acc to the manual (this time full handshake), got myself a new lap top, and tried to delay next line transmission in cimco software, and handshake timeout. I can run the program, but it is still the same thing... When the control runs out of lines, it stops. Discovered that, if i match that line sending delay in cimco with feed, I can run longer programs, or I can "starve" the machine with g code up to some point, and get the job done (not in desired way).
I will be back on this problem later today, and I will share the results for someone with the same problem.
Thanks again, you gave me some ideas, I will try some more...