G-Code

[rwskinner]

In the fadal supplied programs, the Workout program for the 4020 has some g-code I'm not familiar with.

N48(STEP UP THE RPM AND TEST ORIENTATION
N49M+R3S1000
N50G4P2500
N51M19


What does M+R3 do?

Also, I take it these programs assume running from machine Zero or E0 ?

Similar Threads:

• Need help with g code for fire control pocket on AR15 lower reciver, have G code.
• Program to Convert Mill g code To Laser g code - CMTL
• mach3 crashing with run of code/drilling holes through table with other code
• Newbie- corel.hpgl > sheetcam.tap > pronterface.g-code > slic3r.g.code> ramps 1.4 > H-BOT
• Newbie- Takeout Unused G Code commands in Mastercams Generated G Code

[rodney247]

did you load the program from fadal memory?

looks like someone accidentally changed the program its supposed to just be M3S1000 the program is just testing orientation turning spin on, dwell, then orientate

- - - Updated - - -

Run from coldstart yes

[rwskinner]

Yes, it was loaded from eprom. At first, I thought it was a corrupt program but the service program document shows the exact same thing.
I edited all the entries and made some other changes as well.

Its the 4020 Workout Program 05819