fadal 4020 c.n.c spindle

[Adels]

dear sir,
Hello
i am mechanical maintenance engineer
when i replace the bearing of spindle i need to know the correct an arrangement of 2 bearing at the bottom and the 2 bearing at the top of spindlr
bearing number (7210 and 7012 )
thank you sir
Eng. Adel

Similar Threads:

• spindle will not stop fadal 4020
• Need Help!- Fadal 4020 - low spindle rpm
• 4020 fadal spindle orientate failure
• Need Help!- spindle orientation fadal 4020
• HELP ASAP with Fadal 4020 Spindle

[bostosh]

First,
do you have the correct tools to remove and replace these precision parts?
Presses and plugs? Master Machinist available ?

[FadalCNC_Com]

I am not sure how they are configured, but just put them back the way the old bearings came out. If you didn't look, likely I would change paths and buy a reman spindle. You need special tools, precision reloads and assembles in a clean room environment. Any contamination inside the spindle will spell a short life. FadalCNC.com has both new and reman spindles in stock at the best prices on the web.

FadalCNC Tech Support