4x4 Apc machine - Page 2


Page 2 of 2 FirstFirst 12
Results 13 to 14 of 14

Thread: 4x4 Apc machine

  1. #13
    Registered
    Join Date
    Jul 2007
    Location
    United States
    Posts
    4
    Downloads
    0
    Uploads
    0

    Default

    Have you adjusted the Tip Volts on the Torch Height Controlller? You should give our technial support team a call at 903-569-3190.



  2. #14
    Registered
    Join Date
    Feb 2009
    Location
    USA
    Posts
    102
    Downloads
    0
    Uploads
    0

    Default

    Quote Originally Posted by Parm473 View Post
    I have an ez router 4x4 apc plasma machine i have no problems cutting .125 mat i'm trying to set up to cut .187 mat the machine has a miller spectrum 375 plasma torch that i'm using its not cutting all the way through the mat in spots and is leaving alot of slag when it does cut through, anyone have suggestions on amps ,tip volts, and speed i should be using thanks
    Your user manual for the Miller Spectrum 375 should have charts listed to give you a basic guideline of input parameters needed to cut 3/16" plate. I don't know the exact model number you have (there are a few listed for the 375), but using page 21 in this user's manual: http://www.millerwelds.com/om/o225216g_mil.pdf

    I come up with the following:

    40 inches/minute @ 27 amps

    or

    26 inches/minute @ 20 amps



Page 2 of 2 FirstFirst 12

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

4x4 Apc machine

4x4 Apc machine

4x4 Apc machine