Need Help! NC Studio / Weihong PM53C5 DRIVERS


Results 1 to 4 of 4

Thread: NC Studio / Weihong PM53C5 DRIVERS

  1. #1
    Registered
    Join Date
    Jul 2017
    Location
    Mexico
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default NC Studio / Weihong PM53C5 DRIVERS

    Im having problems to install the PCI Card for the NC Studio

    It was already working but the Windows failed and we need to reinstall it

    afterwards the nc studio shows a message " Hardware FAILURE"

    Any advise

    Similar Threads:


  2. #2
    Registered
    Join Date
    Apr 2016
    Location
    Macedonia, The Former Yugoslav Republic Of
    Posts
    12
    Downloads
    0
    Uploads
    0

    Default Re: NC Studio / Weihong PM53C5 DRIVERS

    Hi,
    Did you connected your hardware before installing the drivers? I had the same problem with the ncstudio card. I installed the cylinder drivers and it seems everything to be ok. Try this and try to install the software with the pc and the machine card connected.
    Cheers.

    Sent from my HTC Desire 620G dual sim using Tapatalk



  3. #3
    Registered
    Join Date
    Mar 2018
    Location
    Bangladesh
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default Re: NC Studio / Weihong PM53C5 DRIVERS

    Dear Bro,
    Use Windows XP SP 2 instead of other operating system for your CNC machine.
    This will fix your problem.
    Thanks.



  4. #4
    Member
    Join Date
    Jun 2007
    Location
    New Zealand
    Posts
    8
    Downloads
    0
    Uploads
    0

    Default Re: NC Studio / Weihong PM53C5 DRIVERS

    I have a very similar problem. It was all working well but the computer started having issues so I did a complete hard drive format and fresh install of Windows XP, then installed the controller card and NZStudio (version 8). Now the controller isn't sending a signal to the spinldle inverter or servo drivers, and unfortunately Service pack 2 didn't solve it. The software is working fine and there is movement on screen when I use the jog controllers, but nothing happening on the actual machine.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

NC Studio / Weihong PM53C5 DRIVERS

NC Studio / Weihong PM53C5 DRIVERS

NC Studio / Weihong PM53C5 DRIVERS