Just got 2 Exitech machines, might sell


Results 1 to 6 of 6

Thread: Just got 2 Exitech machines, might sell

  1. #1
    wagnerskis
    Guest

    Default Just got 2 Exitech machines, might sell

    Hi, I work for a custom ski manufacturer in Colorado. We just got 2 Exitech machines from a ski manufacturer in China but are not quite sure if we want or need to keep them & are trying to understand the value of the machines in case we want to sell them. The machines are Exitech 1325a, they each have 4 spindle routers. I am wondering if there may be anyone on the forum who could give us a ballpark estimate of the value if I were to post some photos & more info.
    Many thanks, Cormac.

    Similar Threads:
    Last edited by wagnerskis; 03-30-2016 at 03:13 PM.


  2. #2
    Member
    Join Date
    Apr 2004
    Location
    Canada
    Posts
    475
    Downloads
    0
    Uploads
    0

    Default Re: Just got 2 Exitech machines, might sell

    Depending on what the spindles are, my guess is 9-15k new, $US (I'm in Canada), deprecate according to condition, and know that it's probably not too common of a configuration.

    Sent from my ASUS_Z00TD using Tapatalk



  3. #3
    wagnerskis
    Guest

    Default Re: Just got 2 Exitech machines, might sell

    Thanks, much appreciated info.



  4. #4
    Registered
    Join Date
    Feb 2016
    Location
    United Kingdom
    Posts
    381
    Downloads
    1
    Uploads
    0

    Default Re: Just got 2 Exitech machines, might sell

    Sounds like the generic 1300x2500mm machines sell at $4000-4500 single spindles so think other guesstimate a little high.



  5. #5
    Member
    Join Date
    Dec 2007
    Location
    Australia
    Posts
    2134
    Downloads
    1
    Uploads
    0

    Default Re: Just got 2 Exitech machines, might sell

    If they each have 4 spindles, you may have some luck with companies doing turning work, as these machines are commonly used for newel posts and balusters.

    Door companies would also use them for carved door inserts.

    cheers, Ian

    It's a state of mind!


  6. #6
    Member
    Join Date
    Apr 2004
    Location
    Canada
    Posts
    475
    Downloads
    0
    Uploads
    0

    Default Re: Just got 2 Exitech machines, might sell

    My estimate was for a cheap servo system, DSP controller, steppers and mach3 could be less, I agree but a commercial machine is probably better that the $5000 machines with extra spindles.

    Sent from my ASUS_Z00TD using Tapatalk



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Just got 2 Exitech machines, might sell

Just got 2 Exitech machines, might sell