3D Routing offset

[shmity]

Hi Folks,

I have some curved pressed ply blanks that I need to cut backrests and seats from, ie an outline. Im wondering if theres a way to do a simple routing offset outline with a 3d lift and plunge along the curve. I could do it in 2 open contour offsets and calculate the 3d entry and exit lengths but a single profile would make life easier.

Is there a way to do this in enroute? All the 3d cutting tutes ive found have been for carving complex forms with 3d reliefs.

Cheers!

Similar Threads:

• Need Help!- Tool Offset and Work Offset Locking on Fanuc OiMD
• Newbie- Difference Between Geometry Offset and Work offset
• Need help! Fanuc Work offset, Geometry offset
• Tool offset with work offset
• FANUC 3M G54 OFFSET, H-OFFSET----Please help!!!

[mikepro]

I do not believe there is a simple way to do in versions enroute without 3D enabled, as that sounds like a job for enroute's 3d options:
where you would clamp your panels with a jig to the table, take as accurate measurements as possible, & use the extruding tools program the base-shape/curve as a solid convex-shape, extrude your reliefs above this, and export your toolpaths along their paths.

I believe they still offer a free trial of their new softwares via Sai website if you want to tinker around and give it a shot.