I am using Enroute 5.1.0.39


Results 1 to 2 of 2

Thread: I am using Enroute 5.1.0.39

  1. #1
    norbert_ds's Avatar
    Join Date
    Feb 2019
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default I am using Enroute 5.1.0.39

    Hi all I am new to this forum as well as with enRoute. I cannot seem to find my Construction Toolbar or anywhere in my preferences to turn it On or Off.

    Any help would be much appreciated.

    Kind regards
    Norbert



  2. #2
    Member
    Join Date
    Jun 2015
    Location
    USA
    Posts
    2
    Downloads
    0
    Uploads
    0

    Default Re: I am using Enroute 5.1.0.39

    it should be in the pull out bar under your setup tab. It's been a while since i have use v5, but i but i believe it's still in the same spot.



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

I am using Enroute 5.1.0.39

I am using Enroute 5.1.0.39