Vision 2550 routing table with series 3 contoller, need z axis microstepping settings

Results 1 to 4 of 4

Thread: Vision 2550 routing table with series 3 contoller, need z axis microstepping settings

  1. #1
    Member eccmaster's Avatar
    Join Date
    Apr 2019
    Posts
    2
    Downloads
    0
    Uploads
    0

    Default Vision 2550 routing table with series 3 contoller, need z axis microstepping settings

    Hi
    I need the microstepping jumper settings for the zaxis stepper motor controller. While working on it, I think one of my students change the switch settings, it was all 4 switches on the off position, which results in the motor not working. When I change it to match the same jumper settings as the x and y axis (sw1=on, sw2=on, sw3=off, sw4=on), the z motor works, but when I check the accuracy of the movement with a tape measurement, I am off by amost 50%. After experimenting with different switch settings, I get the best results with sw1=off, sw2=off, sw3=on and sw4=on. Based on the IM2000s datasheets, I believe (if switch on means 0) the x and y axis is set to 32 microsteps and z axis is 16 microsteps. Can any one please verify if this is the correct settings. Thank you

    Similar Threads:


  2. #2
    Member
    Join Date
    Nov 2008
    Location
    USA
    Posts
    5
    Downloads
    0
    Uploads
    0

    Default Re: Vision 2550 routing table with series 3 contoller, need z axis microstepping sett

    Hello,

    The correct resolution settings for the Vision series 3 controller are below:

    X: 3 off
    Y: 3 off
    Z: 1,2 off

    Thanks,
    Joe



  3. #3
    Member eccmaster's Avatar
    Join Date
    Apr 2019
    Posts
    2
    Downloads
    0
    Uploads
    0

    Default Re: Vision 2550 routing table with series 3 contoller, need z axis microstepping sett

    Thank you so much



  4. #4
    Member
    Join Date
    Nov 2008
    Location
    USA
    Posts
    5
    Downloads
    0
    Uploads
    0

    Default Re: Vision 2550 routing table with series 3 contoller, need z axis microstepping sett

    Your welcome.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Vision 2550 routing table with series 3 contoller, need z axis microstepping settings

Vision 2550 routing table with series 3 contoller, need z axis microstepping settings

Vision 2550 routing table with series 3 contoller, need z axis microstepping settings