- Vanguard 3400
-
Registered
Vanguard 3400
I booted up my vanguard 3400 this morning and a message come up on my dos screen. above the "press Pause to resume", a message above read Table 1 relocated origin, x=0.000 y=0.000, once complete my file I try to send it to the engraver and is says to "PRESS SET ORIGIN AFTER GO TO XY.
I reset set origin on mogul and it read x=0.000 and y=8.000 once i send the file over it is not recognizing the correct origin. Any suggestion on what I can do. I hope my problem is explain well enough for you to follow.
I tried to reload the program again, but no luck
Similar Threads:
-
-
Member
Re: Vanguard 3400
hi i just bought one of these archaic machines for $100.... do u like urs?
- Vanguard 3400
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules