LinuxCNC G96 SCC problem


Results 1 to 1 of 1

Thread: LinuxCNC G96 SCC problem

  1. #1
    Member
    Join Date
    May 2016
    Location
    Slovenia
    Posts
    136
    Downloads
    0
    Uploads
    0

    Default LinuxCNC G96 SCC problem

    My 220P is converted to run on LinuxCNC, and at the moment I am using puller to get the stock material out.
    I tried using G96 and CSS for getting optimum finish and good cutting/parting, but after using it, I have a problem with a puller. Although I run the G94 and G97, the puller gets to the last point of G0 command, and wont do a G1.
    Is there something wrong with the code, or is there something in the setup that I should change?
    Thanks
    Stefan

    Similar Threads:
    Attached Files Attached Files


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

LinuxCNC G96 SCC problem

LinuxCNC G96 SCC problem