Hi
Im looking for a manual for the TD-1236B, can you help me with that
Thanks
Ed
Hi and welcome St1977,
I have the Central Machinery TD-1236B shown in one of the pics and farshot83 owns the ENCO 110-2032. He shot me some pics of the drum switch so I could figure out the wiring positions on the drum switch. From there I put some pics up showing the wires positions and colors. If they are not coming thru for you, PM me and I can forward them to you in an email. Just a note, I am not sure if your 110-2031 has the same drum switch as both of ours. There are pics of both his and my drum switches posted so you can determine if yours is the same.
All the best on getting your lathe running and making some chips.
Hi
Im looking for a manual for the TD-1236B, can you help me with that
Thanks
Ed
Thanks I downloaded that, I have several other questions , can we talk ?????
PLMK
Ed
Hi edkel1, I am not sure if I have any answers beyond the manual, but what are your questions?
what kind of oil, its low and dont know what type, where to you get replacement 1/4 turn door handles for the base
I will have more questions as I clean it up
Ed
Hi Ed, The manual says to replenish with 30wt. lubricant. I am not sure that the 1/4 turn handles are aivailable any more. A good little project and seems very easy project. I might be able to shooy a couple pics of the factory handles to give you an idea. All the best, post a few pics as you go along so we can enjoy your progress.
Paul
I have one good handle but have been looking and cant find anything to match it and as far as oil I must have missed it in the manual, thats on me
Thanks for answering
Ed
Paul, is there any other oil I can use instead of DTE Light as in ATF, 5-20w motor oil or should I just stick with the DTE Light and how much will it need mine was real low , got about 32 ozs out of it, I was thinking 2 qts ?????, have lots of questions coming
Thanks
Ed