I recently purchased a MX4660 driver for my DIY cnc
The motors are running perfectly.But I stuck at Home & limit switch configuration (i'm using micro switch)
there are some pins named input1, input2,................ input8
but i don't know how to interface this with Mach3 software
when connecting to the 4 limit switch inputs and E-stop on the first printer port or motion controller port
this may help assuming your using a 12V supply for the limit switches
and do not need to add resistors to use higher voltages - see figure 15 on the manual page 16
PDF manual MX4660hm_V1.1.pdf
assuming your using mach3
in pins and ports - input signals
you need to assign port 1
pin 10 as X limit ,
pin 11 as Y limit
pin 12 as Z limit
pin 13 as X limit
pin 15 as E stop
John
Last edited by john-100; 06-03-2019 at 10:37 AM.
Reason: correct limit switch supply voltage