Your other employee, Mollieosborn, posted in the other forum and has answers. Try doing them.
We have encountered an error with our Brother HS-300 wire EDM after removing and repairing the coolant pump.
Once the pump was repaired the status light shows an error but does not display a cause or error type on the diagnostic screen. Due to the error the controller will not allow for jog, water pumping, or wire feeding.
I have been trying to find a way to reset the machine to factory settings in hope that it will clear this error.
Any information or advice offered would be helpful!
Thank you.
Similar Threads:
Your other employee, Mollieosborn, posted in the other forum and has answers. Try doing them.
Two Haas VF-2's, Haas HA5C, Haas HRT-9, Hardinge CHNC 1, Bother HS-300 Wire EDM, BobCAD V23, BobCAD V28