Need Help! software stuck in sim mode/deactivate pause

Results 1 to 3 of 3

Thread: software stuck in sim mode/deactivate pause

  1. #1
    Member calebmorita's Avatar
    Join Date
    Oct 2021
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default software stuck in sim mode/deactivate pause

    hi, old mentor builds surfboards, uses eding software to control machine. says the software is defaulting to simulation mode, even when following proper startup protocol. when manually getting out of simulation mode, he is getting an alert telling him to "deactivate pause." (see attached photos) any ideas? thanks

    Similar Threads:
    Attached Files Attached Files


  2. #2
    Member Boris_25's Avatar
    Join Date
    Apr 2021
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default Re: software stuck in sim mode/deactivate pause

    Hello,
    What is your hardware card model?
    Is it the first use?



  3. #3
    Member arie kabaalstra's Avatar
    Join Date
    Jan 2007
    Location
    Netherlands
    Posts
    352
    Downloads
    0
    Uploads
    0

    Default Re: software stuck in sim mode/deactivate pause

    I had the same prob.. ehrm Challenge.. Turned out it was nothing more than invert the pause IO in the setup, Page 2



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

software stuck in sim mode/deactivate pause

software stuck in sim mode/deactivate pause