Sinumerik 840 C Post options

[geobuild]

Hi
Does someone know where to find documentation on Edgecam post editing?
I made a post for a Chiron FZ12 with Sinumerik 840C but NC code contains a TURN command which is not recognized by my controller
Which option turn this command off?

thanks

Similar Threads:

• Post DMF 220 Sinumerik 840D
• I need a post processor for Sinumerik 810GA3.
• Need Help!- NX / Sinumerik Post problem
• Need Help!- who has the post for sinumerik 802d
• Need Help!- post-processor for a Sinumerik 840

[timf]

if you open your generator in code wizard and go to NC styles, G-code and modality then select debugging tab and turn on "generate code constructor trace" and repost your program, you will get information about where each piece of code is attached to what cycle or process controlling output so you can go back to the right area in code wizard to tweak what you want to see.