you have to press the "compile" button for wizard to put the generator in the list, have you done that?
it looks like a sheet of paper with a gear in front of it.
i think "ctrl+I" shortcut will also activate compiling
Hi
I’m trying to make a post using the code wizard edgecam 2020. I’ve went through all that’s required but I can’t load it into the available posts I once in the edgecam program. I think I may have to generate a couple of other files as the posts that can be loaded have 3 files the same and I don’t know how to do this! Any words of wisdom appreciated. Thanks
Similar Threads:
you have to press the "compile" button for wizard to put the generator in the list, have you done that?
it looks like a sheet of paper with a gear in front of it.
i think "ctrl+I" shortcut will also activate compiling
Hi Tim
Thanks a lot that’s worked, something so simple!! Feel kinda stupid.
I did the hardest bit then went looking to generate the code without full filling the code generator process, think I was just a bit too keen!
Thanks again now I’ll have ago at making up a post for conversational Heidenhain. Hopefully it’s as straight forward as the Fanuc.