Post: Toolchange block numbers in setup/tooling sheet


Results 1 to 3 of 3

Thread: Post: Toolchange block numbers in setup/tooling sheet

  1. #1
    Member
    Join Date
    Jan 2016
    Location
    Hungary
    Posts
    4
    Downloads
    0
    Uploads
    0

    Default Post: Toolchange block numbers in setup/tooling sheet

    Greetings!
    I want to write all of my toolchange block numbers to setup/tooling sheet in my post, but I dont know how to travel data(TC block numbers) back to the setup sheet code constructor.

    The setup/tooling sheet lists all of my tools in the sequence, but I want to reach later output data(TC block numbers) because in older cnc machines(slower machines) I using block search by block numbers. I dont want to search to eg. T15(string) in the cnc code, i want to search and jump to block numbers immediately. This is useful in cnc codes which has thousand of rows.

    Example:

    **SETUP SHEET**
    N20 (T1 D6 ENDMILL)
    N5614(T2 D8 BALL NOSE)
    N15489 (T3 D10 ENDMILL)
    **SEQUENCE**
    ...
    ...
    N20 T1 M6(D6 ENDMILL)
    ...
    ...
    ...
    N5614 T2 M6 (D8 BALL NOSE)
    ...
    ...
    N15489 T3 M6 (D10 ENDMILL)
    ...
    Tried with MASK but no success.



  2. #2
    Member
    Join Date
    Oct 2003
    Location
    usa
    Posts
    122
    Downloads
    0
    Uploads
    0

    Default Re: Post: Toolchange block numbers in setup/tooling sheet

    you can set the generator to only use block numbers on toolchange lines...N1 =T1... N2=T2, if tools are sequential and non-repeating that may be the simplest fix for your quest



  3. #3
    Member
    Join Date
    Jan 2016
    Location
    Hungary
    Posts
    4
    Downloads
    0
    Uploads
    0

    Default

    Hi timf!

    The machine is a five axis mill with millplus control. In this control blocks without block numbers not allowed, it generates error. The problem is: setup/tooling sheet code contructor is generated first in the code, but tc block numbers comes after, I tried with MASK (i think it allows two pass code generating), but can't figure it out how to properly use it. Something must to do with %SUBROUTINE but no idea how its logic works.

    Thanks for your reply.



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Post: Toolchange block numbers in setup/tooling sheet

Post: Toolchange block numbers in setup/tooling sheet