edgecam opens milling part as a turning part

[unhit]

hi i just starded programing in edgecam. everything was ok so far. i am creating solids in part modeler then transfering it into edgecam. my last part i have done same way as every other but it keeps opening it as a turning part in edgecam. even if i move cpl where i want it to be and find all features when im trying to open sequences it doeasnt let me create milling sequence. did i do something wrong in part modeler ? or i can just change it to milling part in edgecam?



picture of the part attached

Similar Threads:

• optimized sequence when there are multiple part-in-part layout inside a part
• Flipping the part in Edgecam
• Drawing opens, shows part, then turns to "X"
• Newbie- Part holding and milling 3D part on 2.5D Mill?
• Big Blue Saw opens. Your design -> Real part online

[Vegabond]

hi i just starded programing in edgecam. everything was ok so far. i am creating solids in part modeler then transfering it into edgecam. my last part i have done same way as every other but it keeps opening it as a turning part in edgecam. even if i move cpl where i want it to be and find all features when im trying to open sequences it doeasnt let me create milling sequence. did i do something wrong in part modeler ? or i can just change it to milling part in edgecam?



picture of the part attached

Hi!

If you click on the ZX button in the lower right corner, you program in milling mode

[unhit]

Hi!

If you click on the ZX button in the lower right corner, you program in milling mode

Thank You!

[Vegabond]

No problem, just ask and im glad if i can help you