- CNC Brushless DC Servos , drives, cables, power supplies
-
Member
CNC Brushless DC Servos , drives, cables, power supplies
Hello all.
I have taken off my servos and am selling them. You can see from my earlier posts that I was having trouble with my servo drives- the servos are fine- when I updated to Acorn I lost the ability (I am certain it is user error) to use my Z and Y servo drives. The tests I posted on the link are all off the X axis drive. I put this out in ebay to gauge interest. Have a look and if you have any questions please feel free to reach out. These were all working using supercam so they are by no means new but I believe they have little use based on the rest of the machine.
They are quite large.
Here is the deal
You will be getting 3 giant NEMA 36 MCG Servos Rated for 480 oz/in Continuous Torque and 2400 OZ peak oz/in Peak Torque These are not your average CNC servos
1 smaller NEMA 34 - the Z axis.
All motors tested with results shown in the below link. The Z moves fine but I could not test it? Again it works off the X axis.
2 massive power supplies (80+ volts)
Extra capacitor.
All data and power cables. This came off of a 7x12' table and the wires were plenty long.
3 Accelus Drives- I know that the X works- the others seem to want to work but do not! I tested all servos off the X drive.
For more images and data sheets click the link below. I would be happy to answer any questions that I can but my knowledge is VERY limited.
Image Link
https://clarityconsulting.box.com/s/dto ... ggt0c7e13p
Ebay listing:
https://www.ebay.com/itm/283844186501
Of course if you have any interest reach out to me. I am in NW Arkansas.
Similar Threads:
-
-
Member
Re: CNC Brushless DC Servos , drives, cables, power supplies
I see that the image link did not go through as intended.
Below is that link.
https://clarityconsulting.box.com/s/...u61lggt0c7e13p
- CNC Brushless DC Servos , drives, cables, power supplies
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules