KMotionCNC question

[funding33]

In kmotionCNC when gcode executed it looks like G0 commands respect acceleration and jerk limits set in Kflop but G1 - does not. Or may be G1 respect just acceeration but not jerk.

And then what is the relation of Jerk/Acceleration set in Kflop and acceleration set in KmotionCNC?

Similar Threads:

• KmotionCNC 4.34H, init question
• KMOTIONCNC 4.34h, Screen Size Question
• Updating kmotioncnc and firmware question...
• Is anyone using KmotionCNC instead of Mach3?
• KMotionCNC

[TomKerekes]

Hi,

Please read this.