Kmotion Bode plot does not display results

[b5n7i2o5]

I have a question regarding why the Bode plot results are not being shown below the plot after the test is run. I have the latest software version installed on the laptop and Kflop board with Kanalog. I am using a laptop with Windows 10. This is happening on the two laptops I use for testing the control. Is there a bug or do I have something not configured correctly?



Similar Threads:

• Just IN- panel saw appearance display and running process display
• Newbie- advice on step response and bode plot
• Need Help!- Choosing Bode Plot Variables
• Basic question: how do I get Kmotion to create Bode plots?
• Bode Plot? Characterize machine movement

[TomKerekes]

The software uses a 10 point running average of the magnitude to find the 0db crossover so the crossover frequency needs to be greater than ~30Hz to be detected. You can always just look yourself where the crossover is and what the margins are. In your case the crossover is ~5HZ with huge phase and gain margins. You should be able to crank up gains considerably, which will push up the crossover frequency, and then the numbers should be displayed.

HTH