Parallel lines


Results 1 to 7 of 7

Thread: Parallel lines

  1. #1
    Member
    Join Date
    Oct 2014
    Posts
    27
    Downloads
    0
    Uploads
    0

    Default Parallel lines

    Please could you help me. I’ve to put in parallel two line of engines. Examplíe: x with z and y with a. Which is the command that I’ve to applaid?
    Thanks a lot. Dalmazio.

    Similar Threads:


  2. #2
    Member TomKerekes's Avatar
    Join Date
    May 2006
    Location
    USA
    Posts
    3256
    Downloads
    0
    Uploads
    0

    Default Re: Parallel lines

    Hi Dalmazio,

    I don't understand what you are asking. Possibly Master/Slave configuration?

    Regards
    TK http://dynomotion.com


  3. #3
    Member
    Join Date
    Oct 2014
    Posts
    27
    Downloads
    0
    Uploads
    0

    Default Re: Parallel lines

    [QUOTE = TomKerekes; 2341958] Ciao Dalmazio,

    non capisco cosa stai chiedendo. Possibile configurazione Master / Slave ? [/ QUOTE]
    dear tom, yes, x master z slave, y master a slave thank



  4. #4
    Member
    Join Date
    Oct 2014
    Posts
    27
    Downloads
    0
    Uploads
    0

    Default Re: Parallel lines

    dear tom, yes, x master z slave, y master a slave thank



  5. #5
    Member TomKerekes's Avatar
    Join Date
    May 2006
    Location
    USA
    Posts
    3256
    Downloads
    0
    Uploads
    0

    Default Re: Parallel lines

    Hi Dalmazio,

    I'm not sure whether you still have a question.

    It would be better to reference KFLOP Axis Channels. ie.

    X = Master KFLOP Axis #0, Slave KFLOP Axis #2
    Y = Master KFLOP Axis #1, Slave KFLOP Axis #3

    Regards
    TK http://dynomotion.com


  6. #6
    Member
    Join Date
    Oct 2014
    Posts
    27
    Downloads
    0
    Uploads
    0

    Default Re: Parallel lines

    thanks tom, should I write these commands in the consol?





  7. #7
    Member TomKerekes's Avatar
    Join Date
    May 2006
    Location
    USA
    Posts
    3256
    Downloads
    0
    Uploads
    0

    Default Re: Parallel lines

    Hi Dalmazio,

    No you should configure the KFLOP Axes appropriately in the configuration screen as described in the Link I provided. Configure the each Slave axes to follow the appropriate Master.

    Then configure the XY Coordinate System with:
    DefineCoordSystem(0,1,-1,-1); // define X as Axis #0 and Y as Axis #1

    Regards
    TK http://dynomotion.com


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Parallel lines

Parallel lines

Parallel lines