Hi,
Since power was shut off to KFLOP the encoder positions in KFLOP have been lost. And since with power off the axes may have drifted then the actual physical positions may not be the last commanded position of X=30.6715 Y=7.0. So I believe you may as well re-initialize and zero the machine coordinates as the encoder positions were lost anyway.
If you knew the actual position you could re-initialize (which would zero the machine coordinates) then set the GCode Position to the actual position using a GCode Offset (ie Fixture Offset).
How do you normally set up your coordinates? Do you use Tool, Fixture, or Global Offsets? Can you probe your part at some X and Z positions and set the coordinates to be correct at those positions?