Hi Dave,
No. Konnect doesn't have any Step/Dir outputs. The communication to Konnect and optos are too slow to support MHz Step Pulses.Is it possible to direct the Step/Dir output channel to the Opto Outputs on the Konnect board and not use multiplexed JP4, JP6 or JP5 on the KFlop board? (I have attached a Kanalog board to JP7, and have connected the Konnect boards(2) to JP4.)
24V Step/Dir signals are not common unless series resistors are added. Can you remove or change resistors to make them 5V? Otherwise external Voltage level drivers would be required.For my CNC router, I am using six servo drivers/motors that need a 24 volt Step/Dir signal. I prefer the opto isolation provided by the Konnect output ports.
Most Drives already have opto isolation. What Drives do you have?For my CNC router, I am using six servo drivers/motors that need a 24 volt Step/Dir signal. I prefer the opto isolation provided by the Konnect output ports.
That's not possible. If you list all your IO - Analog, Encoders, Step/Dirs, etc and specifications we may be able to help to suggest a solution.Basically what I wish to accomplish is for a given Axis0, instead of the Step/Direction pulses going to IO bits 8 and 9, on JP7, or IO bits 36 and 37 on JP5, can the pulses be rerouted by configuration or by software to Output bits 48 and 49 on the Konnect board?