Issues with G03


Results 1 to 3 of 3

Thread: Issues with G03

  1. #1
    Member
    Join Date
    May 2013
    Location
    USA
    Posts
    62
    Downloads
    0
    Uploads
    0

    Default Issues with G03

    Hi All,

    I have a strange issue with the G03 command, sometimes it will not cut the circle, it moves to the location but does not do the cut.

    I was playing with some test code and found the following:

    Works:
    G00 x2.15 y10.4789
    G03 x2.15 y10.4789 i0.0 j0.65 f20.0

    Does not work:
    G00 x2.16 y10.4789
    G03 x2.16 y10.4789 i0.0 j0.65 f20.0

    Less than .15 works more than .16 on the x does not work. WTF?

    This is in Mach 3 connected to a Kflop/Kanalog system.

    Any thoughts?

    Cheers

    Chris

    Similar Threads:


  2. #2
    Member TomKerekes's Avatar
    Join Date
    May 2006
    Location
    USA
    Posts
    4043
    Downloads
    0
    Uploads
    0

    Default Re: Issues with G03

    Hi Chris,

    Any error/status messages?

    What Version of Mach3?

    What Version of KMotion?

    Inch mode?

    If you split the full circle into two semi-circles does it work then?

    Regards
    TK http://dynomotion.com


  3. #3
    Member
    Join Date
    May 2013
    Location
    USA
    Posts
    62
    Downloads
    0
    Uploads
    0

    Default Re: Issues with G03

    Hi Tom,

    No error messages that I have seen, maybe I should have the kmotion console up to see. In Mach 3 it just goes to the start point sits there for a sec then moves on to the next point without performing the G03 motion.

    I have tried a few versions of Mach 3 with no difference (43.066, 42.020, 43.062). currently running the latest version 43.066.

    Latest version of KMotion

    Yes Inch mode

    I have not tried this but I will.

    Cheers

    Chris



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Issues with G03

Issues with G03