Hi Chris,
Any error/status messages?
What Version of Mach3?
What Version of KMotion?
Inch mode?
If you split the full circle into two semi-circles does it work then?
Hi All,
I have a strange issue with the G03 command, sometimes it will not cut the circle, it moves to the location but does not do the cut.
I was playing with some test code and found the following:
Works:
G00 x2.15 y10.4789
G03 x2.15 y10.4789 i0.0 j0.65 f20.0
Does not work:
G00 x2.16 y10.4789
G03 x2.16 y10.4789 i0.0 j0.65 f20.0
Less than .15 works more than .16 on the x does not work. WTF?
This is in Mach 3 connected to a Kflop/Kanalog system.
Any thoughts?
Cheers
Chris
Similar Threads:
Hi Chris,
Any error/status messages?
What Version of Mach3?
What Version of KMotion?
Inch mode?
If you split the full circle into two semi-circles does it work then?
Regards
TK http://dynomotion.com
Hi Tom,
No error messages that I have seen, maybe I should have the kmotion console up to see. In Mach 3 it just goes to the start point sits there for a sec then moves on to the next point without performing the G03 motion.
I have tried a few versions of Mach 3 with no difference (43.066, 42.020, 43.062). currently running the latest version 43.066.
Latest version of KMotion
Yes Inch mode
I have not tried this but I will.
Cheers
Chris