Hi Mark,
If you are using the Screen Editor then the path is directed to the GViewer on the Main Screen rather than the separate resizable screen. You will need to switch to a Standard Screen Face or enable the GViewer Control on one of your Screens.On my mill I cant seem to get any toolpaths to display at all? I can only use the g-code viewer on my office computer. If i click settings they appear to be the same, but nothing shows up on my mill? Any ideas? Do i have some settings wrong or could a custom screen be causing it?
YesIs this showing the G-code or the path after its ran through the trajectory planner?
You must actually run a Job to see the Trajectory Planned Result.If i change TP settings I see the same result, but in your video here it shows the results of the changes. Are you doing something different here? How are you viewing the changes in the trajectory planner?
Yes. See the help:Is there any other way to zoom other then mouse wheel? If not could the increments be smaller? I find things tend to be too small and then one more increment and its off the screen.
G Code Viewer Screen
Click and drag the right mouse Button to translate closer or farther.
After 3 seconds of moving the resolution increases.