Newbie Need help with eratic cut path!!!


Results 1 to 1 of 1

Thread: Need help with eratic cut path!!!

  1. #1
    Member JewKiddinMe's Avatar
    Join Date
    Nov 2019
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default Need help with eratic cut path!!!

    Hi, I'm working on a dynatorch 12x6 with a hypertherm powermax 85. I'm very new to this table and program since my previous experience was on a plasmacam. My problem is when I load my ready DXF file onto the onboard converter and set the cut order. When it comes out the path has stray and bent lines. I use enroute for my editing and export it as a dxf simplified if that helps. If any other information is needed I am more than happy to give it. I have included pictures of the bad cut path and of how it should look. Would greatly appreciate the help!!!

    Similar Threads:
    Attached Thumbnails Attached Thumbnails Need help with eratic cut path!!!-capture-jpg   Need help with eratic cut path!!!-capture-1-png  


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Need help with eratic cut path!!!

Need help with eratic cut path!!!

Need help with eratic cut path!!!