Newbie Need help with eratic cut path!!!


Results 1 to 1 of 1

Thread: Need help with eratic cut path!!!

  1. #1
    Member JewKiddinMe's Avatar
    Join Date
    Nov 2019
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default Need help with eratic cut path!!!

    Hi, I'm working on a dynatorch 12x6 with a hypertherm powermax 85. I'm very new to this table and program since my previous experience was on a plasmacam. My problem is when I load my ready DXF file onto the onboard converter and set the cut order. When it comes out the path has stray and bent lines. I use enroute for my editing and export it as a dxf simplified if that helps. If any other information is needed I am more than happy to give it. I have included pictures of the bad cut path and of how it should look. Would greatly appreciate the help!!!

    Similar Threads:
    Attached Thumbnails Attached Thumbnails Need help with eratic cut path!!!-capture-jpg   Need help with eratic cut path!!!-capture-1-png  


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Need help with eratic cut path!!!

Need help with eratic cut path!!!