- Need Help!- Dynapath & AD GS23-2010 VFD
-
Member
Dynapath & AD GS23-2010 VFD
Hello,
I have a Tree 325 (Dynapath Delta 20M) with a VS-626MT III Spindle Drive Controller (Fried/Toast).
I have a Automation Direct GS23-2010 that I have already hooked up / configured to work with the Yaskawa UAASKA-04CA1
My next hurdle is to get the Dynapath Delta 20M to "talk" to the GS23 VFD. Looking through all the documentation I have on the Tree & the Dynapath I can not seem to find where to land the cw/ccw terminals & the speed control terminals from the VFD to the Dynapath.
Has anyone done this before / know if this is even possible?
I am able to get the Dynapath to start the VFD/motor via the 12CRE relay and the E-Stop to work vie the 1CRE relay
Also would it be possible to get the motor encoder to talk directly to the Dynapath so it wont spit out the "Drive not up to speed error"
The documentation I have on all components are in the google drive link below.
https://drive.google.com/drive/folde...-V?usp=sharing
Any help is greatly appreciated.
Thanks
Similar Threads:
-
- Need Help!- Dynapath & AD GS23-2010 VFD
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules