Hi machinehop5,
I manage to tune up the servo with the tuning software provided by dmm.
I tune it to rigid in the tuning section with before i tune it to be standard.
So the the problem which i had is solve.
I used to work with stepper motor never with servo motor.
Now the problem is when i switch off the computer , mach 3 and the servo power everything stand still until i turn the computer, i turn on mach 3 , i push the reset button on mach 3.the z axis drop.
Luckily it have the stopper if not the ball bearing going to spread on the floor.
I already power the servo brake with 24v 3a.
Just that i need a advice on the servo motor diagram , how to wire it properly, or as long that the z axis wont fall.
Thank you.
Sent from my SM-N950F using Tapatalk