- Spindle question from a Dynapath Newbie
-
Registered
Spindle question from a Dynapath Newbie
I have only figured out to turn on the spindle using an E event type but i can not stop or start it in a program I have to reset and go through the whole thing again. Is there an easier way? Please say there is!!
Similar Threads:
Last edited by mattmont; 01-23-2015 at 06:57 AM.
-
- Spindle question from a Dynapath Newbie
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules