Please Help! - DynaCNC 4000 Blowing Z Axis Fuses


Results 1 to 2 of 2

Thread: Please Help! - DynaCNC 4000 Blowing Z Axis Fuses

  1. #1

    Default Please Help! - DynaCNC 4000 Blowing Z Axis Fuses

    I have a very large DynaCNC table with a Z axis problem. As soon as I reset Mach 3, the control box kicks in, then out and blows the 10 amp mini auto style fuse. It just started doing this and happens as soon as the reset is pressed on Mach 3. Any ideas on what to check or how to go about troubleshooting would be greatly appreciated. Thanks in advance.

    Thanks,

    Brian

    Similar Threads:


  2. #2
    Member
    Join Date
    May 2007
    Location
    USA
    Posts
    111
    Downloads
    0
    Uploads
    0

    Default Re: Please Help! - DynaCNC 4000 Blowing Z Axis Fuses

    try swapping gecko's between z and x or y and see if the problem follows the gecko.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Please Help! - DynaCNC 4000 Blowing Z Axis Fuses

Please Help! - DynaCNC 4000 Blowing Z Axis Fuses