DM4400 Pull Studs

Results 1 to 2 of 2

Thread: DM4400 Pull Studs

  1. #1

    Default DM4400 Pull Studs

    Hello

    What type pull stud does the 4400 use ?

    BT30 45,°60°,90° or iso30 type ?

    I did look in the dm4400 manual but it only says pullstuds are supplied by Dyna.

    Similar Threads:


  2. #2
    Member
    Join Date
    Nov 2012
    Location
    USA
    Posts
    361
    Downloads
    0
    Uploads
    0

    Default Re: DM4400 Pull Studs

    It uses a custom knob. I need to confirm a dimension, but I believe the attached drawing is correct (but note the DM4400 in the lower right, so it almost certainly is). However, that is probably only for reference. I have mixed feelings about whether or not you would want to make your own. RTS does sell the knobs, but they are not cheap. Their part, 341-14, is $26.46/ea and are apparently stocked. The price is kind of brutal, but thankfully you don't need a ton of them. If you find them less expensive elsewhere, please post here!

    Dyna DM4400 retention knob.pdf

    https://www.retentionknobsupply.com/



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

DM4400 Pull Studs

DM4400 Pull Studs