hy if better control is needed, i like to write the code :
for deep holes, or when drill flute's are relatively too short, you may use the load diagram, in order to fine-tune your codeCode:G00 X0 Z2.5 G01 Z-50 F0.10 G95 Z-50+0.15 Z-55 Z-55+0.15 G00 Z50 ( or, if you wish, feed out slower, at smaller clearance G01 Z2.5 F2000 G94 ) G04 F.... ( maybe dwell a bit ? ) Z-55+1 ( back in ) G01 Z-60 F0.085 G95 ( use slower feed for the last 5mm ) Z-60+0.15 G00 Z2.5
if you wish, i may share drilling codes for osp
by the way, there is a nice okuma forum here : https://www.cnczone.com/forums/okuma/
kindly