Need Help! Tool change goes through part


Results 1 to 3 of 3

Thread: Tool change goes through part

  1. #1
    Registered
    Join Date
    Sep 2016
    Location
    United Kingdom
    Posts
    5
    Downloads
    0
    Uploads
    0

    Default Tool change goes through part

    HI there I am using Dolphin Cam turning module the problem i have is when i simulate the tool path the tool change goes through the part.

    After post processing this runs OK on the HAAS SL20 but looks wrong when checking the tool paths in the software any ideas tried all sorts of setting combinations.

    Kind Regards Mark




    Similar Threads:
    Attached Thumbnails Attached Thumbnails Tool change goes through part-tool-change-simulate-problems-jpg  


  2. #2
    Member
    Join Date
    Jul 2010
    Location
    Australia
    Posts
    178
    Downloads
    0
    Uploads
    0

    Default Re: Tool change goes through part

    Did you solve this? You're geometry/profiles are wrong. You should see the complete part in the cam, not half...



  3. #3
    Member
    Join Date
    Feb 2007
    Location
    UK
    Posts
    412
    Downloads
    0
    Uploads
    0

    Default Re: Tool change goes through part

    I beleive my colleague Michael sorted this out with mods to the post.

    ATB
    Andre

    (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Tool change goes through part

Tool change goes through part