Hello,
Here is a short video on how to do this.
ATB
Andre
sharnoa SD-900 kflop/kanalog W/centroid DC servos
enshu VMC 400 kflop/kanalog W/FANUC DC servos
Hello,
Here is a short video on how to do this.
ATB
Andre
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
thanks
i will mess with it some more
sharnoa SD-900 kflop/kanalog W/centroid DC servos
enshu VMC 400 kflop/kanalog W/FANUC DC servos
You will need to do the maths. There are no g-code instructions for this.
Cheers
Roger
Hello Roger,
I'm sorry but I don't understand your reply.
All you need to do is draw the arc, you can do this by using the three point arc option and choosing the first end point, middle point and second end point.
ATb
andre
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Hi Andre
Ah - you are using a CAD system? I understand.
I was talking about trying to use the G2/G3 instructions in the XZ or YZ planes, in Mach3.
Cheers
Roger