What signal are people using from the DYN4 drive for fault detection?
The ALM (JP4, Pin 18) or the ONPOS (JP4, Pin 6)? I guess the ONPOS (following error?) would stop faster, but the ALM signal is probably what most people use?
I couldn't find any wiring examples, either in the manual, or anywhere else.
Second question. Are you using the previous signal to kill power to the drives, or for the enable signals. If you are killing power the the drives, then I don't see any reason to use the Enable signals?
The manual shows the E-Stop killing power, but nothing about the enables.
Last edited by ger21; 08-13-2017 at 10:07 AM.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)