Originally Posted by
usmarine21m
I'm hoping someone here can answer some questions I have on wiring it up. The manual I find confusing and not for an average self learning cnc'r like myself. I emailed DMM a few days ago and haven't heard back from them yet.
I got a 60A molded case circuit breaker from msc, and hope I got what the manual says is needed, because at 100 bucks I hope it is.
The manual has in it 2 magnetic contactors, and one common noise filter.
I'm having the hardest time finding where to get this stuff and if it is the right thing.
If anyone knows of what I need to get this DYN4 running and where to get it, I'd appreciate it.
In the manual it says for single phase input, connect power supply to R and T terminals on connector T4. Does it matter which one is connected to the 110v hot (black) wire and which is connected to the neutral (white)?
I have the T3 connector for the DYN4 drive that it says goes to a regenerative resistor, do I need to wire this up?
I have 2 DYN4 drives, does that mean I need 2 sets of components?
If anyone knows of what I need to get this DYN4 running and where to get it, I'd appreciate it. If anyone has any pics of theirs that would be nice too. Thanks