I built the 7th Sojourn and liked it well. The table was a bit small for my specific needs. With a little help from John I just finished up the mechanicals for a Routezilla sized machine. It's more of a hybrid of the Routezilla and Pheonix as I migrated the X and Y axis from the 7th to a moving gantry style machine. So far so good. I've not cut anything with it yet because it's going to need some faster speeds to cope with the large size of it. It's got a 28"x16" cutting area. I'm moving to 4v steppers and a 24v power supply in the next few days, which should prove to be much more powerful than what I've been using. I hope to get slightly better than 25" per minute with it. I cut all of the plastic parts and the gantry uprights with the 7th Sojourn and alignment was extremely good on this one. I can turn the lead screws very easily with my fingers and move any of the axis with less effort than I could on my all hand cut 7th. I'm pretty stoked. I can't wait to get my power supply. Where's that damn UPS man?