Stepper Motor Wire Strain Relief


Results 1 to 2 of 2

Thread: Stepper Motor Wire Strain Relief

  1. #1
    Member Project_Hopeless's Avatar
    Join Date
    Feb 2019
    Location
    Sterling Heights Michigan
    Posts
    99
    Downloads
    0
    Uploads
    0

    Question Stepper Motor Wire Strain Relief

    I have some inexpensive NEMA 23 stepper motors. Other than a small rubber grommet where the stepper wire exits the stator/housing, I don't see much in the way of strain relief.

    I'm mainly concerned about the motors on moving parts of my CNC router.

    Is anything else done to provide strain relief to the wires before you can get them in a clamp or conduit?

    Similar Threads:


  2. #2
    Community Moderator Jim Dawson's Avatar
    Join Date
    Dec 2013
    Posts
    4487
    Downloads
    0
    Uploads
    0

    Default Re: Stepper Motor Wire Strain Relief

    The only thing I can really think of is a glob of RTV silicone applied where the wires exit the motor. It would provide some resiliant support for the wires.

    Jim Dawson
    Sandy, Oregon, USA


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Stepper Motor Wire Strain Relief

Stepper Motor Wire Strain Relief

Stepper Motor Wire Strain Relief